Elekit PS-3250 Phono Equalizer Kit
The Elekit PS-3250 is a MM/MC compatible stereo phono stage kit. Offering super low noise and clean RIAA-equalized line-level signal. You can select between an MM and MC cartridge by a jumper on the PCB. This is a kit; you must populate the PCB with the parts provided.
This can be used with any Pre-Amp or Integrated Amplifier. Not exclusively just amps produced by Elekit.
FEATURES
- Featuring the low-noise NJM2068DD OpAmp.
- The passive electronic parts provided are ±1 % tolerance metal oxide resistors, and ± 2％ tolerance film capacitors are adopted to realize small RIAA deviation and low noise.
- A CR design is used for the equaliser circuit, so there is zero deviation in equalization even when OpAmp is exchanged.
- A positive and negative voltage generating circuit is on-board for the power unit, and high-quality sound and wide dynamic range are secured by supplying ±15 V for OpAmp. An external power supply is required (not supplied with the kit). A switch mode power supply is recommended 5Vdc to 12Vdc). The kit does not provide a DC connector.
- POP noise suppressor upon power ON/OFF is on-board. Remember to short if you aren't using a switch.
- The noise level, especially the hum noise, depends largely on the IN/OUT wiring and the grounding location. Therefore, this kit includes an IN/OUT jack and grounding bracket to fix those parts to the PCB.
SPECIFICATION
- Corresponding cartridge: MM (Approx. 47kΩ), MC (Approx.100Ω or 30Ω)
- Circuiting system: CR equalizer (RIAA), OpAmp dual amplification
- RIAA deviation : Within ±0.5dB (20-20kHz)
- Gain (@1kHz) : 27dB(MM, LOW-G), 32dB(MM, MID-G), 36dB(MM,HIGH-G) 56dB(MC, LOW-G), 62dB(MC, MID-G), 65dB(MC, HIGH-G
- Non-clip max. output (@1kHz) : 9V r.m.s.
- Power voltage: 5-12Vdc
- Power consumption (OPamp: NJM2068DD) : 100mA(5V), 30mA(12V)
- PCB dimensions : 100 x 80mm
PRICE (1 off)
£45.95 +vat +p&p
UPGRADE PARTS
We offer the following parts for those who wish to buy the component upgrade kit. Please add the following parts to your cart.
Also, check out the
NewClassD Dual Op-amp - Ultimate Edition MK2 x 2
I would suggest that you fit the op-amp first before you start populating the PCB. Capacitors around them may need some adjustment.
See our instructional Youtube video below on how to construct the Elekit PS-3250 kit