EML 2A3-M: Emission Labs 2A3 Mesh Plate Valve
The EML 2A3-M is Emission Labs’ mesh plate version of the classic RCA 2A3, a directly heated output triode used in low-power valve amplifiers. Each anode has a window of woven wire mesh set into a rigid metal plate. The plate holds the assembly in shape while the mesh helps damp mechanical resonances.
The standard four-pin version is a direct electrical replacement for the original RCA 2A3. In a typical single-ended amplifier, one valve delivers around 3.5W into a 2.5kΩ output transformer primary. A pair in push-pull can deliver around 10W. If you’re choosing a valve for a headphone amplifier or the output stage of a separate preamplifier, Emission Labs recommends its solid plate 2A3, as the mesh version can occasionally produce audible noise in these applications.
Features
- Woven grey mesh windows in the anodes, with a suspended anode and grid assembly to reduce microphonics.
- Gold-plated control grid for low grid current and stable bias.
- Hand-blown glass bulb mounted on a black ceramic base with gold-plated pins. A soft rubber joint between the glass and base helps isolate the assembly from vibration.
For DIY builders, check the filament voltage at the valve pins, where it should measure 2.4–2.6V. If you’re using an electronic filament supply, Emission Labs specifies a voltage-regulated module. The maximum anode ratings apply individually.
Manufacturer’s guarantee — The original purchaser can register the valve with Emission Labs to take part in its five-year guarantee programme, subject to the Emission Labs guarantee conditions.
Specifications
- Valve type: Directly heated mesh plate output triode
- Base: Four-pin UX4
- Filament supply: 2.5V AC or DC at 2.5A, with a voltage tolerance of ±4% at the valve pins
- Maximum standby time with filament supply only: 2 hours
- Maximum anode voltage: 350V
- Maximum anode current: 70mA
- Maximum continuous anode dissipation: 18W
- Maximum grid-to-ground resistance for standard 2A3 single-ended circuits: 500kΩ with cathode bias or 50kΩ with fixed bias
- Typical single-ended operating point: 250V anode voltage, 60mA anode current and −45V grid bias, giving 15W anode dissipation
- Typical single-ended output: 3.5W into a 2.5kΩ primary load
- Anode resistance at the single-ended operating point: 800Ω
- Amplification factor: 4.1
- Transconductance: 5.2mA/V
- Typical push-pull operating point: 300V anode voltage and 40mA idle current per valve, with a separate 780Ω cathode resistor for each valve
- Typical push-pull output: 10W per pair into a 5kΩ anode-to-anode primary load
- Dimensions including base, excluding pins: 147mm high × 60mm diameter
Sold as a matched pair.
PRICE (pair)
£655.00 +vat +p&p